Silentwind Pro Generator and supporting structure

I have a Silentwind 400 Pro generator and support structure that was specially designed for my Contessa 32. It also comes with an integrated solar panel. It all works perfectly and seamlessly and was installed by the previous owner for extended cruising. I am using the boat for racing and hence it is no longer needed. The support structure also provides a convenient and very neat integral hoist for outboards etc and an array for GPS, VHF antenna to keep them out of harms way. The Jeremy Rogers yard is currently professionally removing the gear ready for re-installation. The new price for the whole kit was circa £4,000. I am looking for £990 but am open to offers.

The SILENTWIND 400 PRO is ultralight and aerodynamic.
As the noise emission is very low you can operate the SILENTWIND 400 PRO in marinas, on-board sailing yachts without irritating your neighbours.
The included Bluetooth charge controller is suitable for 12, 24 & 48-volt usage and comes with a Solar input too.
Housing the internal electronics away from the generator itself means that your SILENTWIND 400 PRO has little need for any maintenance work. Power is fed to the charge controller by 3 cables.
The hand-laminated carbon fibre blades have been successfully tested in accordance with DIN EN 61400-2 in a wind tunnel up to wind speeds of 35m/s (63 knots). Therefore you need not worry about the SILENTWIND in any conditions. If there is a need for any maintenance work, there is an additional manual stop switch.
Its certainly an advantage being able to use the renewable energy of both wind and sun combined. Charging your batteries by way of both daylight and wind for 24 hours, the SILENTWIND Hybrid 1000 charge controller will manage this for you, up to a maximum input of 550w (40A).
Silentwind were proud sponsors of the Volvo Ocean Race, you can see the products used on all of the boats as a true power source.